laload.blogg.se

TeamViewer 9 Manual Wake-on-LAN of 13ĥ Set up Windows 3 Set up Windows In order to wake up the computer, it must be appropriately set up.

If these requirements have been met, you can move on to configure your computer and the software in the next steps. The computer is in one of the following power states Sleep Start > Sleep Hibernation Start > Hibernation Shut down (Soft off) Start > Shut down not supported under Mac OS X Supported power states. The computer is connected to the Internet via a network cable. The computer's network card supports Wake-on-LAN. The following checklist ensures that the computer is suitable for Wake-on-LAN: The computer is connected to a power source. TeamViewer 9 Manual Wake-on-LAN of 13Ĥ Requirements 2 Requirements In order to successfully wake up a computer by Wake-on-LAN, its hardware must meet several requirements. Unless stated otherwise, the functionalities described always refer to the TeamViewer full version for Microsoft Windows.

This manual describes the necessary requirements and steps to use TeamViewer Wake-on-LAN.

Wake up a computer via its public address (see section 5.3, page 10). Wake-on-LAN can be used through two different methods: Wake up a computer via another computer within the same network (see section 5.2, page 9). This way, you can control an offline computer remotely by waking it up before you establish a connection. 3 About Wake-on-LAN 1 About Wake-on-LAN You can turn on an offline computer with TeamViewer via Wake-on-LAN.